Furnace flue liners
Smaller liners for gas or oil furnaces and water heaters stop condensation from damaging the chimney.
Chimney Parts
Chimney Liner Installation Clarion, PA
A Clarion chimney sweep can reline your chimney with a liner sized to the appliance and insulated where the system calls for it. Call (814) 538-2091 to reach a local chimney sweep.
Inside most chimneys is a liner, the tube that actually carries smoke and flue gases to the top. It keeps heat from reaching wood framing next to the chimney, protects the brick and mortar from corrosive gases and gives the appliance a flue of the right size to draft well. Some older chimneys were built unlined, and others have clay tiles that have cracked over the decades.
Most liner installations start with one of these situations. Damaged clay tiles, missing mortar between tiles or no liner at all are the most common triggers. Installing an insert, stove or high efficiency furnace often means the old flue is the wrong size.
Before relining, the chimney should get a thorough inspection, usually a Level 2 inspection with a camera run up the flue. The inspection tells you whether relining is truly needed and what kind of liner suits the chimney. Ask to see the camera video so you understand what was found.
Chimney Liner Installation is often paired with chimney liner repair and chimney inspection, depending on the cause.
Dealing with this in Clarion, PA right now? Call (814) 538-2091 and describe the problem to a chimney sweep who works in Clarion.
Call nowThe process
The chimney relining process
A liner has to fit the flue, the appliance and the chimney route.
Inspect the flue
A camera is run through the flue to check the existing tiles, offsets and obstructions. This confirms what kind of liner the chimney needs.
Match the appliance
Sizing follows the appliance it will serve, since too big or too small both cause problems. The route and any offsets are noted.
Clean the flue
Creosote and debris are cleaned out first, and broken tiles may be removed to make room. The path from top to bottom has to be clear.
Install the liner
A flexible liner is fed down the flue, while rigid sections are joined as they go. Insulating it helps draft and reduces creosote and condensation.
Connect the appliance
A tee or connector joins the liner to the appliance, and a top plate seals the crown. The connections keep gases from leaking into the old flue.
Confirm venting
A draft test confirms the new liner is working. Keep carbon monoxide alarms on every level of the home.
What is included
Chimney liner options
Rigid liners
Rigid stainless sections join together in straight chimneys which suits wood burning appliances well.
Cast in place liners
A cement based mix is poured around a form inside the chimney to create a smooth new flue in a single solid lining.
Flexible stainless liners
A flexible liner works in chimneys that are not perfectly straight which makes them the most common relining choice.
Insulated liners
Liners can be insulated with a blanket or a poured mix where the system or chimney calls for it.
Related service
Stainless Steel Chimney Liner Clarion, PA
Most relining jobs use stainless steel, which handles high heat and corrosive flue gases well. Flexible stainless goes around offsets in a chimney, and rigid stainless suits straight runs. The sweep picks a grade of stainless that suits the fuel the appliance burns.
Insulation around the liner helps flue gases rise and keeps the outside of the chimney cooler. At the top, a sealing plate and cap keep rain and animals out. Many Clarion chimneys get a stainless liner when an old fireplace is converted to an insert.
Related service
Chimney Relining Clarion, PA
Relining means putting a new liner into a chimney that has an old, damaged or missing one. The most common triggers are chimney fires, settling cracks, missing mortar and appliance changes. Most chimneys can be relined from the roof without opening walls.
Have a list of everything that uses the chimney ready when you call (814) 538-2091. A furnace replaced with a high efficiency model that vents through the wall can leave the water heater alone in an oversized flue, which leads to poor draft and condensation. A smaller liner brings the draft back where it should be.
Local help
Chimney Liner Installation Near Me
Around Clarion, relining usually comes up when a home changes heating appliances or an inspection turns up cracked tiles. From Clarion out to places nearby like Marianne, Knox, Rimersburg and New Bethlehem, wood stoves and inserts are common, and each one needs a properly sized liner, and a new liner is often the safest long term fix.
Need chimney liner installation around Clarion? Call (814) 538-2091 for a Clarion chimney sweep who serves the towns around it too.
What the local climate does to a chimney
Winters here are long and cold, and the heating season usually runs from October well into April. Masonry takes the worst of it from the freeze and thaw cycle: rain and melting snow soak into the crown and joints, then freeze and push them apart, and each winter widens the cracks a little more. Nor'easters drive rain sideways into flashing and mortar that looked fine in summer. Most homeowners in Clarion, PA schedule a sweep in early fall, and a repair check after a hard winter.
Why call
Why fix it now
Smaller repairs
Small chimney problems caught early usually stay small repairs.
Local knowledge
Chimney sweeps in Clarion know the chimneys and fireplaces common in local homes.
Clear next steps
Ask your questions before you agree to anything.
Chimney Liner Installation FAQ
How long will a new chimney liner hold up?
A quality stainless liner, installed and maintained properly, can last for decades. Chimney fires, heavy creosote and corrosive condensation are what shorten their life. The liner manufacturer usually gives guidance on care.
What does a chimney liner do?
Chimney liners keep heat and gases inside the flue, away from wood framing and the brick itself. Unlined chimneys or broken liners can let heat or carbon monoxide escape. A sweep can check the flue and tell you where you stand.
Why does my water heater flue need relining after a furnace upgrade?
When a home switches to a high efficiency furnace that vents out the side of the house, the water heater may be left as the only appliance using the chimney. The oversized flue lets gases cool and condense, which weakens draft and wears out mortar. The fix is a properly sized liner, plus CO alarms in the home.
Can an insert vent into an existing chimney without a liner?
NFPA 211 expects a positive connection from the insert to the flue, and a full length liner is the common way to do it. Venting an insert into an oversized clay flue leads to poor draft and heavy creosote. The insert manual will list the venting requirements.
What is the difference between a clay liner and a stainless liner?
The original liner in most masonry chimneys is clay tile, which is durable until a chimney fire or settling cracks it. Stainless steel liners are installed later, from the top, and are used to reline chimneys whose tiles are damaged or missing. Minor tile damage can sometimes be repaired instead.
More questions? Call (814) 538-2091
Related services
Chimney Liner Repair
Repairing cracked clay flue tiles, open joints and damaged liners with resurfacing, joint repair or partial replacement.
Learn moreChimney Inspection
A level 1, 2 or 3 review of the full chimney system to catch cracks, blockages and leaks before they turn into hazards.
Learn moreFireplace Insert Installation
Installing wood, gas and pellet inserts in existing fireplaces, so more heat stays in the room instead of going up the flue.
Learn moreWood Stove Installation
Wood stove installation into an existing chimney or a new insulated chimney, so the stove drafts well and stays clear of anything that can burn.
Learn more
Looking for something else?
See all chimney servicesNeed chimney liner installation in Clarion, PA?
Call (814) 538-2091 to talk to a chimney sweep serving Clarion, PA.
(814) 538-2091
Free to call. No forms to fill out.